Temp3: -128.0☌ (low = +95.0☌, high = +24.0☌) sensor = disabled First we need to install lmsensors: yum install lmsensors Next, use sensors command to display CPU temperature: sensors grep Core Core 0: +43.0C (high +86.0C, crit +100.0C) Core 1: +43.0C (high +86.0C, crit +100. The voltage on the CPU core goes from about 1.1 to 0.9 when stressing. Clock speeds are about 2.9Ghz when stressing. In6: +0.67 V (min = +1.39 V, max = +2.38 V) ALARMģVSB: +3.84 V (min = +0.58 V, max = +0.79 V) ALARM When stressing the cpu, the temperature goes slowly (in a couple seconds instead of instantly) from about 50C to around 75C and stays there comfortably. Sensors is a command-line utility that displays sensor chip readings in real-time. Analyzing Sensor Information Using the sensors Utility Another tool to get CPU temperature on Linux is sensors. After that your ram sticks temperature will be visible on sensors command. So in this article, we look at 3 different ways you can monitor your hardware temperature levels. First part is 'address' and second part is the bus path to create new device. Linux doesn’t come with a very intuitive way of checking in on your CPU/GPU. After that you need to indicate which addresses are need to used with this driver. Finally to get your CPU temperature type sensors in your terminal. In0: +2.80 V (min = +0.29 V, max = +0.41 V) ALARM Press the S key on your keyboard to toggle sensor details. To read temperature, we need Jedec module, jc42 loaded into kernel. 21 Answers Sorted by: 766 Install lm-sensors sudo apt-get install lm-sensors After installation type the following in terminal sudo sensors-detect You may also need to run sudo service kmod start It will ask you few questions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |